×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco LEAP extensions in Centrino integrated wireless cards

Unanswered Question
Oct 21st, 2003
User Badges:

Hi,


I downloaded the current drivers for the wireless NIC from Dell. I'm using the configuration GUI that comes with it. I'm not getting very far when I try to connect to the AP.


I am wondering if I have to use the Cisco Client to configure the NIC? Or is the GUI that comes with the laptop (Intel(R)ProSet) the one to use?


Thanks,


Kim


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
derwin Sun, 10/26/2003 - 20:29
User Badges:
  • Cisco Employee,

Hi Kim,


Does the GUI that you have the option to enable Cisco LEAP and configure it ? If so that should be ok to use.


The Cisco ACU is only designed to work with a Cisco card.


If you think you have it configured correctly and it is not working then run the EAP debugs/diags on the AP and see where it is getting to in the process


David

kimlong Tue, 10/28/2003 - 06:34
User Badges:

Hi,


Thanks for the input. After enabling/disabling various options, and contacting Dell, we came to the conclusion that it won't work.


Even though the Dell website claims it is interoperable, the wireless tech support person I spoke to when I opened a case said, "We just tell people it doesn't support LEAP because it doesn't work".


So, the only way I could get it to work was to disable MIC and "Cisco" on the AP Security Settings/VLAN and leave them at

none. On the client side, I enabled all the Cisco extensions, and included a login id and password.


I could see the authentication process on our ACS working and the client would be associated and authenticated on the AP.


Kim

Actions

This Discussion