806 router duplex mode

Unanswered Question
Oct 21st, 2003
User Badges:

I connected a Cisco Catalyst 2950 switch in fourth interface of my router 806. On the switch, auto-detection sets the ports 10Mbps/Half Duplex.


Does the 806 router supports 10Mbps/Full duplex ?



Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rmcarthur Wed, 10/22/2003 - 00:06
User Badges:
  • Bronze, 100 points or more

No, it has only a 4 port 10base-T hub.

lunestadr Thu, 10/23/2003 - 22:57
User Badges:

What about the wan eth. interface on 806, it has the duplex commands, but when I try to set it, it does not show in config. Is it also locked to 10/half ?


regards rolf

rmcarthur Fri, 10/24/2003 - 00:28
User Badges:
  • Bronze, 100 points or more

Hi Rolf, no it seems that the wan port is also only 10baseT.


Regards

Actions

This Discussion