×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Grouping multiple ds0's from multiple T1 trunk

Unanswered Question
Oct 22nd, 2003
User Badges:
  • Silver, 250 points or more

AS5400-HPX and multiple TDM carriers entering my VoIP network via CT3. I know that using trunk grouping feature I can group trunks, ie, full T1's, and assign the trunk group to dial-peers and do whole lot of stuff.


What I am looking for is, if there is a way to group say 5- ds0 from say 10- T1's together into a group, and use that group into a dial-peer?


Thanks,

Partha

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ketpatel Mon, 10/27/2003 - 11:54
User Badges:
  • Cisco Employee,

I dont think this is possible with PRI circuit but if you have CAS circuit I believe you can configure in following manner and have single ds0 picked out from a full T1. Please check the example attaced below. In the case below I have ds0 13 singled out from 2 T1's and both ds0 is assigned a single trunk group ID cisco#1


Hope that helps..


Regards,

ketan


!

controller T1 2/2

framing esf

linecode b8zs

ds0-group 0 timeslots 1-12 type e&m-fgb

ds0-group 1 timeslots 13 type e&m-fgb

ds0-group 2 timeslots 14-24 type e&m-fgd

cas-custom 0

trunk-group MCI

cas-custom 1

trunk-group cisco#1

cas-custom 2

trunk-group AT&T

!

controller T1 2/3

shutdown

framing esf

linecode ami

ds0-group 0 timeslots 1-12 type e&m-fgb

ds0-group 1 timeslots 13 type e&m-fgb

ds0-group 2 timeslots 14-24 type e&m-fgd

cas-custom 0

trunk-group MCI

cas-custom 1

trunk-group cisco#1

cas-custom 2

trunk-group AT&T

!


Actions

This Discussion