Port Speed and CIR on Frame Relay circuit

Unanswered Question
Oct 23rd, 2003
User Badges:

I would like to know how to verify the Port Speed and CIR that the Telecom gives us on a Frame Relay circuit.


We have Cisco Router 2620XM with IOS 12.2.


Regards,

Giovanne

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
scottmac Thu, 10/23/2003 - 18:53
User Badges:
  • Green, 3000 points or more

You can put a PC on each end of the connection running an application like QCheck (www.netiq.com - free), or you can hit one of the bandwidth test sites like www.broadbandreports.com or www.bandwidth.com.


Using QCheck will give you a bit more control, and will work for "point-to-point" frame-relay circuits (between two locations versus location-to-Internet).


If you couple the Qcheck tests with a detailed bandwidth report from your provider, and / or statistics from the interface of your router, and / or a protocol analyzer, you can evaluate your shaping and policing by looking at FECNs, BECNs, timeouts, re-transmits, etc...


Good Luck


Scott


Actions

This Discussion