×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Using Vlan's on a Cisco 2610XM with 16 Ether switch module

Unanswered Question
Nov 6th, 2003
User Badges:

I am planning to use a 2610XM with a 16 10/100 EtherSwitch module. I want to allocate Vlan's to the Etherswitch ports but transmit the Vlans over the TCP/IP or Bridged interface on the 2610 router. This link will terminate on another router and then reverse the process to output the separate Vlan's.


How can I do this?, I have done this when using physical interfaces (separate Switch & Router) but not when the switch and router are combined?


Anyone have any pointers?


Thanks


[email protected]


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion