×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Acting as a DHCP client...

Unanswered Question
Nov 20th, 2003
User Badges:

Is there any known way to configure a cisco 2620 router to pick up a DHCP assigned address on a FE port? I'm looking to NAT traffic from an DHCP assigned IP to a private LAN, using the access lists to control access.


Any known solution with what I have? Currently using a stock Cisco 2620 router with a single port F/E module and 16MB FLASH.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gfullage Thu, 11/20/2003 - 20:54
User Badges:
  • Cisco Employee,

You mean like this:


int FastEthernet0

   ip address dhcp


ip nat inside source list 100 interface FsatEthernet0 overload

Actions

This Discussion