×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

EIGRP Network command won't accept wildcard

Unanswered Question
Nov 22nd, 2003
User Badges:

I'm setting up a lab with some old 2500 routers. I noticed that the EIGRP network command won't accept wildcards, and the route shows up in the table as a classfull route. I have tried the "IP Classless" command w/ no luck. The IOS is 12.0(9) and the lab involves GRE over IPSec with NAT.


Any Ideas?


Thx, Randy

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thisisshanky Sat, 11/22/2003 - 20:37
User Badges:
  • Purple, 4500 points or more

The network command for EIGRP with mask option was introduced into Cisco IOS starting with 12.0(4) T. Note that this is a T train IOS. I would think that you might need to upgrade to a T train or use an IOS from 12.1/.2 or .3 series.

Actions

This Discussion