12-09-2003 05:04 AM - edited 03-09-2019 05:48 AM
Dear All,
I have a 831 (HQ) which has a static IP and a Soho91 (BO) which has a
dynamic ip (xDSL).
Is there a way to build up the tunnel automatically from the BO the
the HQ, that the HQ can access data in the BO?
The only way I found is to configure the BO as ezvpn client, but I
didn't get the routing done.
Can somehone help?
Thanks a lot!
Best
Christian
12-30-2003 11:36 AM
Hi Christian,
The best way to do that is using EZVPN in Network Extension Mode, client and server the way you defined above.
If you're willing to run some routing over the tunnel, ie, OSPF/GRE etc., then you can use DMVPN (IPSec/GRE with NHRP).
http://cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008014bcd7.shtml
hope that helps.
thanks
Afaq
01-01-2004 11:38 PM
Dear Afaq,
thank you for your reply. EZVPN looks like the best
way to solf my problem. Is it posible to do spoke to spoke communication between the ez-vpn clients?
Thanks
Christian
03-11-2004 05:24 AM
Spoke-to-spoke traffic flows trough the ez-vpn server. IOS and Concentrator support this, while PIX do not allow spoke-to-spoke through the center. It is PIX restriction by design.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: