inverse ARP

Unanswered Question
Dec 30th, 2003

For Frame Relay hub and spoke topology which interface configurations will allow inverse ARP to resolve IP addresses-

-multipoint or point-to-point subint or main int for hub router?

For spoke routers I think only point-to-point subint.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
kkalaycioglu Tue, 12/30/2003 - 04:03

According tohttp://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a0080087d01.html#1002586 document FR inverse-arp is enabled by default on all kind of interfaces but for point-to-point subifs you don't need to enable or disable it because for each point-to-point subif there's one destination- one DLC so no further address discovery/mapping is required (probably you'll be using frame-relay interface-dlci commands.).

Regards.

Actions

Login or Register to take actions

This Discussion

Posted December 30, 2003 at 1:33 AM
Stats:
Replies:1 Overall Rating:
Views:386 Votes:0
Shares:0
Tags: No tags.
 

Discussions Leaderboard

Rank Username Points
1
thisisshanky
2,069
2
pkhatri
1,746
3
ankurbhasin
1,704
4
gpauwen
1,629
5
Richard Burts
1,583
Rank Username Points
xavierchang@hot...
5
Nandan Mathure
5
thiland
5
aacole
5
singhaam007
4