01-05-2004 03:02 PM - edited 03-02-2019 12:40 PM
I am converting a cat6513 to IOS. It's currently connected to 7 cat3500XL via gig ports. Gig ports are span between two blades on the 6513 created etherchannels to all cat3500xl (example: 6513 port 3/1 and 4/1 connected to cat3500-1 port 0/1 and 0/2). We are trunking vlans on these etherchannels. Because I have a short window for this project, I wanted to create the new config before blowing it up. Can someone please verify the below etherchannel and trunk config? Thanks in advance.
interface Port-channel1
description to IWD-01-A-3524-1B
no ip address
switchport
switchport mode access
spanning-tree portfast
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 1,3
interface GigabitEthernet3/1
description to IWD-01-A-3524-1B 0/1
no ip address
logging event link-status
logging event bundle-status
switchport
channel-group 1 mode on
interface GigabitEthernet4/1
description to IWD-01-A-3524-1B 0/2
no ip address
logging event link-status
logging event bundle-status
switchport
channel-group 1 mode on
01-05-2004 06:12 PM
If you are trunking, you will not need "switchport mode access" under the interface
You'll also need to configure trunking under the physical interfaces. Document for reference
01-05-2004 06:24 PM
Excellent white paper. Thank you very much.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: