×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CCM 3.1(3a) and a 1760 16 port FXO

Unanswered Question
Jan 5th, 2004
User Badges:

What version CCM can I configure a 1760 16 ports FXO gateway on?


I would like to configure a 1760 with four 4port FXO cards. Each 4 port card must be able to be divided into two separate FXO H323 gateways on each 4 port card.

In other words I would like to get 8 different H323 gateways on the 1760, each gateway using/alternating between 2 FXO ports.

Is this even possible to do?


Thanks

Rob



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ebreniz Fri, 01/09/2004 - 08:09
User Badges:
  • Silver, 250 points or more

From the CCM's perspective, the 1760 would behave as a single H.323 gateway only. However, if your intention is to have select numbers for a set of

fxo ports, create one route-pattern for each set of fxo port and configure the dial-peers in the 1760 appropriately to handle this.


Another option is to use DNS. Have 8 DNS entries for the same 1760 and use the above mentioned dial-peer configurations. CCM 3.1(3a) that you have is fine for the above solutions.

Actions

This Discussion