startup-config problem

Unanswered Question
Jan 21st, 2004
User Badges:

when i issue any command that tries to access the startup-config, i get the warning message: %% Non-volatile configuration memory is being accessed, Try again later". What's causing this? what's the fix? can't find anything on the cisco website.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
milan.kulik Thu, 01/22/2004 - 00:00
User Badges:
  • Red, 2250 points or more

Hi,

which platform are you using?

I noticed something similar in the past on Cat4006.

The reason were some http server configurations and an CatOS bug.

The only solution was a switch reset.

But I also lost a part of the config.

So I strongly recommend an immediate running config backup!!!

Another possible reason might be a network management system failure. It might be trying to read the startup config all the time in a loop.


Regards,

Milan


Actions

This Discussion