×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

switch harware identification

Unanswered Question
Jan 21st, 2004
User Badges:

Mod Port Model Serial # Versions

--- ---- ------------------- ----------- --------------------------------------

1 2 WS-X6K-SUP1A-2GE SAD04460J3K Hw : 7.0

Fw : 5.3(1)

Fw1: 5.4(2)

Sw : 7.2(2)

Sw1: 7.2(2)


What does Fw mean/used for & why they are 2 Fw -- Fw & Fw1..


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Burts Sun, 02/20/2011 - 20:22
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Ty


This is a very old thread to try to re-start. You probably would be better off to start a new thread and ask your question as a fresh issue.


In the context of the original post FW is FirmWare. We do not have enough information to give a good answer about fw and fw1. My guess is that there are two different modules/cards each with its own firmware but the display in the original post only contained the slot port model information for the slot with supervisor.


If you have a similar situation then perhaps you could post the output of show module from your switch? If we had a more complete output we might be able to give better answers.


HTH


Rick

Actions

This Discussion