×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

"Always Hot Ring Down Line"

Unanswered Question
Jan 23rd, 2004
User Badges:

I have been asked to configure an always hot ring down line on my VoIP solution using CM 3.3.3. Is this nothing more than a speed dial button that someone would press to dial the other end automatically? Or is there something else I should be looking at?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
azam_anwar Fri, 01/23/2004 - 13:12
User Badges:

You could configure PLAR on your CM. With this implemented, a user would pick up a handset and then a preconfigured destination number would be called automatically, without any digits needing to be entered. Not sure if this is what you are looking for?


If you want a solution for a phone(s) that would be configured with an existing DN, then you could try using speed dials or translation patterns instead.

sealc Fri, 01/23/2004 - 13:19
User Badges:

Thanks, I will look into both proposed solutions.

Actions

This Discussion