×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

1721 router configuration

Unanswered Question
Jan 29th, 2004
User Badges:

Im am trying to configure a 1721 router. It was configured before. I am not able to enter any commands such as end, enable, configure.... I get the prompt monitor:command "exit" not found. The next line comes up as rommon 3 > and anything entered gets the same response....What am I doing wrong??? I turned off power and restarted it to see if it would reset, but no luck.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion