×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

How to view active connections with PDM?

Unanswered Question
Feb 2nd, 2004
User Badges:

Is there a way to view active connections to the internet using PDM? And is there a way to disconnect just one connection?


Thanks,

J

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
r.state Wed, 02/04/2004 - 15:29
User Badges:

can't be done using PDM - hopefully this may become an added feature in the future, but for now only the "show conn" cli command will show this info.



shannong Thu, 02/05/2004 - 06:35
User Badges:
  • Silver, 250 points or more

Using Tools in the PDM, you can use [show conn local x.x.x.x] This will show all connections associated with the internal address x.x.x.x.


While you can't clear particular connections, you can clear the xlates associated with the connection to cause the connection to be closed.


[clear xlate local x.x.x.x] would clear any translation and all related connections for the IP. If you're using PAT, you can use the extended form of the command to specificy the actual ports of the translation which would clear a single connection that was associated with it.

shannong Thu, 02/19/2004 - 10:24
User Badges:
  • Silver, 250 points or more

I also wanted to add that you can use the [shun] command to kill a particular connection/session. In addition to blocking the next packet even if the connection is already open, the Pix will close the existing connection when using the [shun] command.


shun src_ip [dst_ip src_prt dst_prt [prot] ]

Actions

This Discussion