Unity server with 2 nics and ip addresses

Unanswered Question
Feb 2nd, 2004
User Badges:

I want to know if Unity 4.0(2) supports two nics with different ip addresses. It currently has both active, but when i check the VM ports on the Call Manager, Unity has registered into CCM with the IP Address of the second NIC, which is non-routable. It actually sits on the same VLAN as the CCM using NIC1. Can i change the source address??

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
eschulz Mon, 02/02/2004 - 21:01
User Badges:
  • Cisco Employee,

The "Configuring Dual NICs in the Cisco Unity Server" section in the Installation guide should answer your question. Here's the link for 4.0(2)...


Basically, you have three options...

1. Run a fault tolerant mode

2. Disable TCP/IP for the second NIC

3. Disable the second NIC in the BIOS


This Discussion