02-25-2004 03:08 AM - edited 03-02-2019 01:49 PM
Please does the below support DLSW. We are trying to connect Ethernet to Ethernet to pass SNA traffic though. Our end is a Cat6509 with Show module as below. Will the below support this. ?
Thanks
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok
2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby
16 2 1 Multilayer Switch Feature WS-F6K-MSFC no ok
3 3 8 1000BaseX Ethernet WS-X6408-GBIC no ok
5 5 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
6 6 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
7 7 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok
8 8 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok
9 9 16 1000BaseSX Ethernet WS-X6416-GE-MT no ok
The MSFC in the Cat6509 has the following show version
Cisco Internetwork Operating System Software
IOS (tm) MSFC Software (C6MSFC-JSV-M), Version 12.1(13)E1, EARLY DEPLOYMENT RELE
ASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Thu 07-Nov-02 23:25 by eaarmas
Image text-base: 0x60008BD8, data-base: 0x61B22000
ROM: System Bootstrap, Version 12.0(3)XE, RELEASE SOFTWARE
BOOTLDR: MSFC Software (C6MSFC-BOOT-M), Version 12.1(3a)E4, EARLY DEPLOYMENT REL
EASE SOFTWARE (fc1)
Thanks
02-25-2004 08:24 AM
It should. Make sure your code has the IBM feature set.
02-26-2004 02:39 AM
Thanks
What do you mean by IBM feature set?
Thanks
02-26-2004 11:51 AM
Here is the tool to research your question:
http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl?Introduction=True
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: