URGENT!!! - Cat6509 and DLSW

londint · ‎02-25-2004

Please does the below support DLSW. We are trying to connect Ethernet to Ethernet to pass SNA traffic though. Our end is a Cat6509 with Show module as below. Will the below support this. ?

Thanks

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok

15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok

2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby

16 2 1 Multilayer Switch Feature WS-F6K-MSFC no ok

3 3 8 1000BaseX Ethernet WS-X6408-GBIC no ok

5 5 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

6 6 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

7 7 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

8 8 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok

9 9 16 1000BaseSX Ethernet WS-X6416-GE-MT no ok

The MSFC in the Cat6509 has the following show version

Cisco Internetwork Operating System Software

IOS (tm) MSFC Software (C6MSFC-JSV-M), Version 12.1(13)E1, EARLY DEPLOYMENT RELE

ASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Compiled Thu 07-Nov-02 23:25 by eaarmas

Image text-base: 0x60008BD8, data-base: 0x61B22000

ROM: System Bootstrap, Version 12.0(3)XE, RELEASE SOFTWARE

BOOTLDR: MSFC Software (C6MSFC-BOOT-M), Version 12.1(3a)E4, EARLY DEPLOYMENT REL

EASE SOFTWARE (fc1)

Thanks

vmiller · ‎02-25-2004

It should. Make sure your code has the IBM feature set.

londint · ‎02-26-2004

Thanks

What do you mean by IBM feature set?

Thanks

apf3885 · ‎02-26-2004

Here is the tool to research your question:

http://www.cisco.com/cgi-bin/Support/CompNav/Index.pl?Introduction=True