×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

international calls fail

Unanswered Question

I have a customer who has CM 3.33sp4a, H232 gateway with a T1 for LD. The dial pattern 9.011XXXXXXXXXXXX

and the following dial peer

dial-peer voice 9011 pots

destination-pattern 9011............

port 1/0:1

prefix 011


When the call gets placed it rings then a recording comes on call can't be completed.


When I do a SH VOICE CALL STAT on the router it shows


0x1C0C2 151D 0x81B2AE64 1/0:1.20 8/4 *0396980059 g711ulaw 0/9011



debug out showes that it can't find prefix for DP


Mar 1 19:59:55: //114540/xxxxxxxxxxxx/CCAPI/cc_api_call_disconnect_done:

Mar 1 19:59:55: cannot find prefix for dp 9011 called number 9011390396980059

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: not incoming

entry

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: entry's incom

ing FALSE.

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: is_incoming i

s FALSE

Mar 1 19:59:55: //114540/80A70910A201/CCAPI/cc_delete_call_entry: Deleting prof

ileTable[0x81DE2598]



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
trailman73 Tue, 03/02/2004 - 06:41
User Badges:
  • Bronze, 100 points or more

I would first change the dial-peer number. Make it something in the 90-99 range. I know this can cause problems. Why don't you just use the route pattern in CCM and not make a specific dial-peer. It should pick up the default dial-peer that you have for the location.


Geoff

Actions

This Discussion