cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
313
Views
0
Helpful
3
Replies

Playoutdelay in Voice

spremkumar
Level 9
Level 9

hi all

wht should be the nominal/max/min values ??

this is the current values set.

Playout-delay Nominal is set to 60 ms

Playout-delay Maximum is set to 200 ms

Playout-delay Minimum mode is set to default, value 40 ms

how much we can configure or how much we can set to have good voice quality .

regds

prem

3 Replies 3

pbarman
Level 5
Level 5

It depends! Normally the defaults are good enough. Only if you experiance problems like choppy audio, high jitter, poor voice quality, you are supposed to play with it.

Check this link for more details and suggestions:

http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1834/products_feature_guide09186a008008033c.html#41701

Thanks,

Partha

Hi partha

i agree with you since nothing to do with default playout settings if evrything works fine,but in my scenario the fixed delays r too high ,so i m trying to compensate the same thru Variable delays.i couldnt fix the fixed delays or avoid them...

regds

prem

Cisco recommends a nominal value of 10ms. The minimum and maximum values depends on your network condition. Minimum is the minimum delay that the jitter buffer will correct, and maximum is the maximum jitter buffer width (max delay that will be corrected by the jitter buffer).

Thanks!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: