×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

5500 Supervisor IIIG swap out

Unanswered Question
Mar 12th, 2004
User Badges:

Hi,

I am going to swap out a fault supervisor IIIG from a switch with 2 supervisor engines.

The faulty card is in slot 1 and I am obviously going to make the card in slot 2 the active card before a start but I can't remember what if anything I need to do to get the config onto the new card.

I think the switch will just recognise that the configs are different and do the necessary but I am not sure ????

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Prashanth Krishnappa Fri, 03/12/2004 - 08:19
User Badges:
  • Cisco Employee,

That is correct. Once you install the replacement Sup, the config will automatically sync from the active

Actions

This Discussion