×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Switch to Switch connection

Unanswered Question
Mar 31st, 2004
User Badges:

Trying to connect a 10/100 port on a C2924M-XL-EN to a 10/100 port on a C2950C. Am using a cross-over cable between RJ-45 ports with matching speeds (100) and duplex (full ) on both Switches. I removed Spanning-tree portfast on both ports.

I can not connect. Thanks for any help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Georg Pauwen Wed, 03/31/2004 - 10:27
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 WAN

Hello,


can you post the configurations of both switches ? How is your VTP configured ?


Regards,


Georg

htaluja_2 Thu, 04/01/2004 - 07:09
User Badges:

I am assuming, by "I can not connect" you mean there is no communication b/w 2 devices..one on each switch. I am going make a simple suggestion first: check the link light. Second see if trunking/native vlan configuration is done correctly.

Actions

This Discussion