×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

4T1-IMA in a 2651XM?

Unanswered Question
Mar 31st, 2004
User Badges:
  • Bronze, 100 points or more

The dynamic configuration tool let me place a

NM-4T1-IMA in a 2651XM config as recently as yesterday. Now it doesn't show up. The compatibility matrix shows this NM is good to go in a 2600. What's wrong here?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rlcarr Thu, 04/01/2004 - 08:10
User Badges:

Mark,


Cisco announced back in October that these would be end of sales on 3/31/04.


http://www.cisco.com/en/US/customer/products/hw/routers/ps259/prod_eol_notices_list.html


Nice huh?

When we moaned to our SE's about this the response was, "Just move to fractional T3's". It appears that Cisco is now try to drive carrier behaviors in addition to end-user behaviors.


We are working on a work around using the AIM-ATM with two VWIC-2MFT's. But this also means we have to introduce ED code using T train into our *stable* GD mainline environment.


Ron

Actions

This Discussion