×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Call Manager reads all digits-not reading Num-digits

Unanswered Question
Apr 4th, 2004
User Badges:

I have CM 3.3(3) installed. I have added a T1 CAS with E&M immediate start gateway. I have added it to CM.


The gateway registers with CM, I can make outbound calls. But, when I call inbound, CM is reading all seven digits, not using the num-digits, which is set to 2.


If I add the extension as seven digits, the incoming call rings. If I try to use my DID, which is based on two digit extensions like "51", the call fails.


This works flawlessly on my PRI, but not this T1 CAS.

Thanks in advance,

Ken

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
johnson.k Mon, 04/12/2004 - 06:48
User Badges:

Thanks. I finally fixed it late Friday!


Here was the deal...in the channel config for each E&M trunk, the "Expected-Digits" was set to zero and "Num-digits" was set to 2.


I changed the "Expected digits" to seven, which is what I saw in dome debugs, and reset the gateway.


That fixed it. I figure that CCM was watching for 10 digits and got confused.


Anwyay, thanks for the input...I'm still going to check the link you sent.

Ken

Actions

This Discussion