12-15-2004 08:41 AM
Is there a Cisco solution to relay/translate between RTP sessions? I will have an application which will handle the signalling itself between VoIP end devices but would like to use a professional equipment to connect the medaia streams transported in RTP.
Thanks,
Gyorgy Kracher
12-16-2004 04:03 AM
Not completely clear on the exact application and the network setup. But have a look at IP-to-IP Gateway, which supports the RTP Flow through mode (besides flow around mode), but IP-to-IP Gateway will be involved in the signaling as well:
http://www.cisco.com/en/US/partner/products/sw/voicesw/ps5640/index.html
Another thing you may look into (depending upon your application) is inserting a Firewall in the middle: PIX will modify the RTP/RTCP port numbers in case you use PAT/NAT and VoIP Signaling will be inspected by PIX and modified in case of NAT/PAT.
12-16-2004 06:05 AM
Thanks for the reply. This IP-to-IP gateway is something similar what I need, but as I see it cannot be used without signalling.
I am not able to open this link with my CCO account. Can you send the doc in email to gkracher@euronetworldwide.com.
Many thanks again,
GK
12-16-2004 09:02 AM
Try the below URL:
http://www.cisco.com/en/US/products/sw/voicesw/ps5640/index.html
You'll find IP-to-IP Gateway Datasheet, Q & A etc and it should work without any need of a CCO userid. If it still doesn't work, then I can email you the docs.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide