enable portfast on all ports of 2950.

Unanswered Question
Dec 27th, 2004
User Badges:


Sorry I corrected my question.


Can I enable portfast on all ports of a Catalyst 2950

by one command:


Config#spanning-tree portfast default


or I can only enable portfast on a per port basis.


thanks




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Georg Pauwen Mon, 12/27/2004 - 02:51
User Badges:
  • Green, 3000 points or more
  • Cisco Designated VIP,

    2017 WAN

Hello,


you can either use the global command 'spanning-tree portfast default', which will put all ports in portfast mode, or the interface command 'spanning-tree portfast' to enable portfast on a specific port.

Further, you can also use the 'interface range' command to configure portfast on a range of interfaces, e.g.:


interface range FastEthernet0/1 - 24


HTH,


GP

Simonwan Mon, 12/27/2004 - 03:09
User Badges:


Hi GP thanks for your help.


For the interface range command.

Should I do it in Config# mode

or should I do it in Config-if# mode


Thanks

Actions

This Discussion