×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

trunk on 2600 router

Unanswered Question
Sep 18th, 2005
User Badges:

dears,

i have 2610xm router when i want to define the encapsulation on fastethernet 0/0.1 and 0/0.2 intefaces i didn't find the encpsuation command . and when i want to add ip address i have the following message :

% Configuring IP routing on a LAN subinterface is only allowed if that

subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q,

or ISL vLAN.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Harold Ritter Sun, 09/18/2005 - 07:03
User Badges:
  • Cisco Employee,

Dot1q encapsulation is not supported in the IP only feature set. A minimum of IP Plus is required to support this feature.


Let me know if I answered your question,

seegomaa Wed, 09/21/2005 - 03:35
User Badges:

many thanks hritter

it worked well aftr downloading IP/PLUS

thisisshanky Sun, 09/18/2005 - 07:30
User Badges:
  • Purple, 4500 points or more

To add to above post, to download IP Plus version, you either need smartnet on your router, or atleast priviliged access to Cisco Software center (CCO Login) if you have smartnet on similar products. Or else you can buy the IP Plus IOS for a couple of 100 dollars.



zgxo10 Sun, 09/18/2005 - 17:05
User Badges:

Hi,

you will need IP Plus to configure encap on sub-interfaces

Cheers

Geoff

Actions

This Discussion