09-18-2005 06:27 AM - edited 03-03-2019 10:31 AM
dears,
i have 2610xm router when i want to define the encapsulation on fastethernet 0/0.1 and 0/0.2 intefaces i didn't find the encpsuation command . and when i want to add ip address i have the following message :
% Configuring IP routing on a LAN subinterface is only allowed if that
subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q,
or ISL vLAN.
09-18-2005 07:03 AM
Dot1q encapsulation is not supported in the IP only feature set. A minimum of IP Plus is required to support this feature.
Let me know if I answered your question,
09-21-2005 03:35 AM
many thanks hritter
it worked well aftr downloading IP/PLUS
09-18-2005 07:30 AM
To add to above post, to download IP Plus version, you either need smartnet on your router, or atleast priviliged access to Cisco Software center (CCO Login) if you have smartnet on similar products. Or else you can buy the IP Plus IOS for a couple of 100 dollars.
09-18-2005 05:05 PM
Hi,
you will need IP Plus to configure encap on sub-interfaces
Cheers
Geoff
09-23-2005 07:28 AM
Hi All,
what is smartnet, and more importantly, how do you know if a device has it.? Cheers.
coolboarderguy...
EDIT:
Ah, google is yr friend...
http://www.cisco.com/en/US/products/svcs/ps3034/ps2827/ps2978/serv_home.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: