×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Digit Timeout - what service parameter

Answered Question
Sep 27th, 2005
User Badges:

The phone goes back to dial tone after about 2 seconds in the middle of

referencing a phone number to dial. Example, 724 (after a few seconds it goes to dialtone). Is there a service parameter to adjust this time.


I know there is the Off-hook to first digit parameter, but is there a parameter for any digit that follows the first? Thanks.


Correct Answer by rnarayana about 11 years 10 months ago

Hello,

Is this an internal number or external number.If it is external number then that means calmanager is finding a match after 724 and it is giving a dialtone.


If you are looking for interdigit timeout it is T302.But I don't think that is the problem


Thanks,

Radhika

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Correct Answer
rnarayana Tue, 09/27/2005 - 06:53
User Badges:
  • Bronze, 100 points or more

Hello,

Is this an internal number or external number.If it is external number then that means calmanager is finding a match after 724 and it is giving a dialtone.


If you are looking for interdigit timeout it is T302.But I don't think that is the problem


Thanks,

Radhika

Actions

This Discussion