Hi,
I'm getting my 1721 set up to connect via PPPOE and when I try to run the vpdn enable command I get this:
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#ip routing
Router(config)#ip subnet-zero
Router(config)#ip classless
Router(config)#end
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#vpdn enable
^
% Invalid input detected at '^' marker.
Router(config)#
Is there a different command for this now?
TIA.
Jon