Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
350
Views
0
Helpful
3
Replies

DHCP and VLANs

Chris Driggers
Level 1
Level 1

‎09-30-2005 06:06 AM - edited ‎07-04-2021 11:10 AM

Here is my scenario. I have a Cisco Cat3550 switch. Three of the ports are set to access mode for vlan 2. My WLSE Express is plugged into one, my 1210 AP is plugged into another, and my laptop is plugged into the third. The switch is my DHCP server.

When the AP or my laptop boot up, they receive IP addresses from the switch correctly. The AP receives its config file from WLSE and is online.

The problem is that when I connect to the wifi, which is assigned to vlan 2, I don't receive an IP address via DHCP. When I'm plugged into the switch I do.

I've attached my config file for the AP. Can anyone tell me what I am doing wrong here?

Labels:
Preview file
4 KB
0 Helpful
3 Replies 3

stschmidt
Level 1
Level 1

‎09-30-2005 07:50 AM

What version of IOS is on this AP?

0 Helpful

stschmidt
Level 1
Level 1

‎09-30-2005 07:51 AM

Also what is the native vlan on the switch?

0 Helpful

Chris Driggers
Level 1
Level 1
In response to stschmidt

‎09-30-2005 09:15 AM

I'll have to check on the IOS, but the native vlan is 1.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card