×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

access control - IP address and MAC

Unanswered Question
Oct 5th, 2005
User Badges:

Hi All,

I have list of Mac addresses and also have range of IP addresses.. how to deny users with condition below:

Range of IP addresses: 172.16.2.241 to 172.16.2.250

List of MAC Addresses: (stored in a file named maclist)

01:02:03:04:05:0c

01:02:03:04:05:0d

01:02:03:04:05:0e

01:02:03:04:05:0f

01:02:03:04:05:4a

When Incoming package from the ranged IP address (172.16.2.241 to 172.16.2.250) then the mac address must be checked from the list of MAC Address, if the MAC Address matched then it allowed otherwise it will be rejected or dropped..

please advise

thanks a lot in advance

Regards

Winanjaya

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
smalkeric Tue, 10/11/2005 - 06:43
User Badges:
  • Silver, 250 points or more

MAC address filters allow or disallow the forwarding of unicast and multicast packets either sent from or addressed to specific MAC addresses. You can create a filter that passes traffic to all MAC addresses except those you specify, or you can create a filter that blocks traffic to all MAC addresses except those you specify. You can apply the filters you create to either or both the Ethernet and radio ports and to either or both incoming and outgoing packets.For further information look at rhe following url:

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_and_configuration_guide_chapter09186a008017281f.html

jackko Tue, 10/11/2005 - 15:19
User Badges:
  • Gold, 750 points or more

just wondering what sort of device you would like to apply these rules on.

Actions

This Discussion