×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Source based routing with 3750 layer 3 switch

Unanswered Question
Oct 6th, 2005
User Badges:

Is it possible to do source based routing on a 3750 switch? This is my core vlan routing device.


Here is the situation. I have a vlan which I want all traffic (including internet) to default to 3725 router, to be shuttled out it's serial port, rather then sent to the default route.


I know this is done through policy based routing, as I have done it before on the 3725. However, after creating the route-map, when I go into the vlan interface I cannot run the command "ip policy route-map <name>". It stops at policy, saying it's an undefined command.


Does anyone have any idea on how to do this on a a layer 3 switch, or can it not be done?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dbellaze Thu, 10/06/2005 - 15:04
User Badges:
  • Bronze, 100 points or more

I'm pretty sure PBR is supported on 3750's. It may require enhanced image though. Do a show version and see if you are running standard or enhanced image.


Daniel

Actions

This Discussion