×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Adding physical interfaces - any effect on config ?

Unanswered Question
Oct 10th, 2005
User Badges:

I want to replace the VAC+ card in my PIX 525 with a 4FE-66 card. Will this have any adverse effect on my PIX when I boot it up after the swap ? The VAC+ card is in the bottom PCI slot. That is where I plan to install the 4FE-66 card. Running PIXOS 6.3

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
bigchoice75 Mon, 10/10/2005 - 09:20
User Badges:

no, you should be fine. Keep in mind the following:


1. If you are doing any type of ipsec tunneling removing the VAC+ will impact the performance of your pix


2. If you are using a failover unit make sure both primary and secondary units have the same hardware otherwise failover will not work.



good luck



Actions

This Discussion