×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Output of show int po1 etherchannel doesnt show load?

Unanswered Question

Hi,


I have a set of 3750 switches which are stacked into 2 sets of 3. I have creted a port channel on each stack that connects to the other stack, as it is cross stack I have used channel-mode on. when i type the follwoing command, some values show as zero, is this a bug, or just not supported?


show interface po1 ether


Age of the Port-channel = 18d:03h:58min:11s

Logical slot/port = 10/1 Number of Ports = 3

GC = 0x00000000 HotStandBy port = null

Port state = Port-channel Ag-Inuse

Protocol = -


Ports in the Port-channel:


Index Load Port EC State No of bits

------+------+------+-------------------+---------

0 00 Gi1/0/28 On/FEC 0

0 00 Gi2/0/28 On/FEC 0

0 00 Gi3/0/28 On/FEC 0



Shouldnt I see the Load entries and bits entries change from 0?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion