×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

BGP attributs <match tag> and <set metric >

Unanswered Question
Oct 20th, 2005
User Badges:

Hi,

can someone tell me how to use those attributs with cat 6509 (version 12.2 (18) SXD4.

because they don' t run when i try to implement them .

here is an example of the config i try to implement:


route-map metric permit 10

set metric 1


route-map solmetric permit 10

match metric 1


6509-C(config)#router bgp 100

6509-C(config-router)#raddress-family ipv4 vrf vrf2

6509-C(config-router-af)#redistribute connected route-map metric out


6509-C(config)#router bgp 100

6509-C(config-router)#raddress-family ipv4 vrf vrfST

6509-C(config-router-af)#neighbor 210.10.10.2 route-map solmetric in


% "solmetric" used as BGP inbound route-map, metric match not supported %


Thank





  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Harold Ritter Thu, 10/20/2005 - 08:00
User Badges:
  • Cisco Employee,

match metric is not supported with inbound BGP route-map. Only the following attributes are supported:


match ip address

match as-path

match community

match nlri

match extcommunity

match policy-list

match mpls-label


Hope this helps,

Actions

This Discussion