×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Design question

Unanswered Question
Oct 25th, 2005
User Badges:
  • Bronze, 100 points or more

Is this a valid design? Any implementation issues to look for? If this is not possible please suggest a workaround. Thanks.


CTI RP (DN1000)-> Unity CallHandler:

Press 1: -> Rings Hunt Pilot DN2000-> Hunt Group members-> No answer - Leave VM at subscriber DN2001

Press 2: ->Rings Hunt Pilot DN3000-> Hunt Group members-> No answer - Leave VM at subscriber DN3001


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Chris Deren Tue, 10/25/2005 - 12:41
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

It will work. When you say "No answer" I hope you do not mean callForwardNo answer on any of the hunt list memebers? You need to create either a dummy phone or cti port or cti rp with vm profile that has 2001 or 3001 set as the vm mask, and that the phone/port has forward all to voicemail checked, also make sure to check the "always route member" for this port under hunt list members.


Chris

yshraybman Tue, 10/25/2005 - 13:36
User Badges:
  • Bronze, 100 points or more

To handle hunt list No Answer should I create a hunt group with CTI RP that point to 2001 vm mask and put in the same hunt list? Or is there a better way to hand this?

Thanks.

Chris Deren Tue, 10/25/2005 - 15:08
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

That is the correct way to do this.


Chris

Actions

This Discussion