×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Setting up voice Lab with 2621 and FXS but voice port stays offhook

Unanswered Question
Oct 30th, 2005
User Badges:

I am working on setting up a lab environment with ITS and CME with a 2621 router running 12.3.8T with FXS ports. However as soon as I connect the pots line and do a sho voice call, I can see the following;

1/1/1

vtsp level 0 state = S_WAIT_RELEASE_RESPvpm level 1 state = FXSLS_OFFHOOK_

ALERT

vpm level 0 state = S_UP


The line will eventually go to park status. I tried different signaling, both loopstart and groundstart. I even tried disconnect-ack and connection plar. I am sure I am missing something simple. Does anyone have any thoughts as to what I am missing?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
patrick.murphy@... Sun, 10/30/2005 - 15:20
User Badges:

If your are having FXS port problems you may want to check your phone cord. I had an issues last week on an FXS card using a 4 wire phone cord. I replaced it with a 2 wire (2 centre pins) and the issues went away.


This was using a VIC2-2FXS.


Patrick

Actions

This Discussion