×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Access to webserver

Unanswered Question
Nov 1st, 2005
User Badges:

Hi,


I know that this might sound stupid, but our Cisco expert has left the company. My boss would like me (little knowledge of Cisco) to configure our Cisco Pix, to enable people to access our webserver.


The pix is currently configured and working for our Exchange webmail, but unsure how to configure it for people externally to access our webserver.


Can any body give me any ideas.


Again I know it sounds silly, but hope somebody could help.


Peter

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
nathan.deane Tue, 11/01/2005 - 11:52
User Badges:

all you will need is the public IP address that you want to use for your webserver, private address of the webserver if you want to dedicate a single IP to be used for the webserver.


A NAT instance needs to be configured so all traffic to the specific public ip will be forwarded to the given private ip


eg


static (inside, outside) 209.165.201.12 10.1.1.3 netmask 255.255.255.255


you then may want to put an access-list on so only specific ports will be allowed through to the webserver


eg


access-list acl_out permit tcp any host 209.165.201.12 eq www


then apply the access-list


access-group acl_out in interface outside





Actions

This Discussion