×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
ankurbhasin Sun, 11/06/2005 - 02:27
User Badges:
  • Red, 2250 points or more

Hi Kapishhohole.


To create more than 1 SPAN session on your cat6k with CATOS you have to use "create" keyword.



Something like this


set span tx create


Remember few guidelines


If you do not specify the keyword create with the set span command and you have only one session, the session will be overwritten. If a matching destination port exists, the particular session will be overwritten (with or without specifying create). If you specify the keyword create and there is no matching destination port, the session will be created


I am posting you the link for cat6k span configuration on catos please read the span session limits and config guideliens


http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sft_6_1/configgd/span.htm#1019851


HTH


Ankur




Actions

This Discussion