11-06-2005 01:18 AM - edited 03-09-2019 12:56 PM
can filover work on PIX 515 using the serial cable only without any addtional
hardware. ( there is two interfases only E0 and E1 )
and if possible pls send to me samlpe of the configuration needed.
thanks
11-06-2005 02:40 AM
Hi seegomaa,
Yes failover can work when only connecting the serial cable, but in this case there will be no stateful failover; this means that no information about the connections that have been established will be shared with the standby unit which will cause active connections to be lost if the primary unit failed.
A sample config with no stateful failover is like:
failover
failover ip address outside 192.168.1.2
failover ip address inside 172.16.1.2
Hope this helps!
Best Regards,
Haitham
11-07-2005 06:15 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide