×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

view "debug" with Telnet connection

Answered Question
Nov 8th, 2005
User Badges:

I have a router in a remote location so I can't use the console port. I have to connect via telnet. Is there a way that I can view debug messages as they are coming in, like I can with the console port?

Correct Answer by ankurbhasin about 11 years 9 months ago

Hi Corey,


Just one command


"terminal monitor"


Check this link


http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hcf_r/cfn_12h.htm#wp1037494



HTH


Ankur

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
mainesy Tue, 11/08/2005 - 10:17
User Badges:

Yes, you can just type the following command at the enable prompt after enabling debugs:


Enable# terminal monitor


That will allow debug messages to be logged to your telnet session.


Josh

Actions

This Discussion