×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
ankurbhasin Thu, 11/10/2005 - 23:47
User Badges:
  • Red, 2250 points or more

Hi Frined,


You can enable "ip accounting" when it is highly utilized and after sometime just run the command "sh ip accounting" to get the toptalkers.


Regards,


Ankur

olorunloba Fri, 11/11/2005 - 01:47
User Badges:
  • Silver, 250 points or more

Enabing netfow is often helpful also. Configure ip route-cache flow on the interfaces, and use show ip cache flow to see the result.


Netflow gives more information, such as source and destinaton ip address, soruce and destination ports, ip protocol type and number of packets in active flow.

Actions

This Discussion