×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Two different public ip addresses NAT'd to the same inside address?

Unanswered Question
Nov 14th, 2005
User Badges:

I am trying to find a way to have 2 different public ip's go to the same interface on a pix. BGP is not an option. The networks are from two completely seperate providers. I am just curious to know if i could do what is in the example below.



2801:

ip nat inside source static 10.10.10.1 2.2.3.1 extendable

ip nat inside source static 10.10.10.1 1.1.2.1 extendable


int fa0/1

description ***** Connection to pix 501 *****

ip address 10.10.10.1 255.255.255.252


PIX 501:

description ***** Connection to 2801 fa0/1 *****

ip address outside 10.10.10.2 255.255.255.252



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Mon, 11/14/2005 - 23:31
User Badges:
  • Red, 2250 points or more

Hi


Can u revert whether you are connecting to 2 ISPs for reduandcy kidna purpose of load balancing ??


regds


jeffdanderson Tue, 11/15/2005 - 08:21
User Badges:

I am looking for a reduandancy solution. Inbound load-balancing isnt so important, just want a way to reach the pix using either t1 for access incase one of the T1 goes down. Maybe setup a round-robin dns for both ip addresses and setup the vpn client with a hostname instead of an ip address.


Looking for any solution that doesnt require BGP or more hardware.

Actions

This Discussion