×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VG224/248 pinouts

Answered Question
Nov 17th, 2005
User Badges:

Hi,

I am going to be installing a mixture of VG224s and VG248s in my building. What I am looking to do is run an amphenol cable to my old telco rooms so I can reuse existing cabling. I need to find out the pinouts from the VG so I can punch down to a 66 block for cross connects. Specifically, which of the pins are not used. Is it the last 2 of the 50 pin cable? I know this is probably a stupid question, I just need to verify so we can have cables run.

Thanks,

Jeremy

Correct Answer by Brandon Buffin about 11 years 9 months ago

Take a look at the following link. I believe it will give you what you need.


http://www.cisco.com/en/US/products/hw/switches/ps708/prod_installation_guide09186a00804197df.html#wp38398


Hope this helps. If so, please rate the post.


Thanks,

Brandon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion