×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

7920 with one way audio (microphone doesn't work)

Unanswered Question
Nov 29th, 2005
User Badges:

Hello,


I am using Callmanager 3.3(3) with a 7920 with 1.09 firmware. The phone was working fine after I set it up. Users started to complain about a one way audio problem the next day. The phone recieves voice but does not transmit.


Phone seems to be stuck on mute. Switching back and forth with the mute soft key doesn't resolve the problem. Any ideas?


With Regards,


Aaron McQuaid

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
smalkeric Mon, 12/05/2005 - 11:25
User Badges:
  • Silver, 250 points or more

I had a similar issue. I am not sure how it got resolved. One thing is the phone load of 2.0.1.


markanthony Mon, 12/12/2005 - 16:33
User Badges:

i had the same problem. THe AP's usually transmit at 100mW however some phone loads on the 7920 transmit at 20mW by default. Because the receiving signal was strong I could hear but was having difficulty transmitting. Bumped up the transmitting signal strength to 50mW on all the 7920 phones and fixed the problem.

Aaron S Mcquaid Tue, 12/13/2005 - 08:12
User Badges:

Hello Mark,


Thanks for the reply. Where do you adjust this setting on the phone or on the access point. I am using o lynksys SRX AP.


With Regards,


Aaron McQuaid

Actions

This Discussion