×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SRST-->WAN-->UNITY/CCM

Unanswered Question
thisisshanky Fri, 12/09/2005 - 13:11
User Badges:
  • Purple, 4500 points or more

This is not something you want to happen, under non-srst mode - correct ? So if you use connection plar, you will always route calls to the AA in Unity. (Unless you manually remove the command out of there).


Under SRST mode, how would you dial the outbound call to Unity ? Is it again going out through the PSTN using a 10 digit prefix (11 digit for londdistance) to dial Unity pilot number via the PSTN ?


If then you can put a default-destination command under call-manager-fallback mode and have it route to a 10 digit number which is the pilot number of Unity AA.


http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_guide_chapter09186a008018131b.html#wp1350685


PS: Please remember to rate replies!

Actions

This Discussion