Configuring Gigabit Ethernet ports in a OSM-4OC3-POS-SI+ module

Unanswered Question
Dec 19th, 2005
User Badges:

Hi,

I'm trying to configure one of the GE port of a OSM-4OC3-POS-SI+ module as a TRUNK port, and another one as ACCESS port in a Cat6503 but when I try to configure:


R-MAN-A(config-if)#switchport mode access

Command rejected: Gi2/2 not a switching port.


Do you know if these ports only can work as ROUTED ports? or maybe is it possible to configure them as TRUNK or ACCESS ports ?


Thanks a lot in advance


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Gallagher Mon, 12/19/2005 - 04:10
User Badges:

Try configuring it as a switchport first:



switch#sh run int g1/1

Building configuration...


Current configuration : 61 bytes

!

interface GigabitEthernet1/1

no ip address

shutdown

end

switch#conf t

Enter configuration commands, one per line. End with CNTL/Z.

switch(config)#int g1/1

switch(config-if)#switchport mode acc

Command rejected: Gi1/1 not a switching port.

switch(config-if)#switchport

switch(config-if)#switchport mode acc

switch(config-if)#

switch#

Actions

This Discussion