×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cat6500 conversion from hybrid to native

Answered Question
Dec 21st, 2005
User Badges:

Is there a tool that will covert your existing supervisor configuration to a native IOS configuration?

Correct Answer by thisisshanky about 11 years 8 months ago

Please be aware that not all configs will convert properly with this tool You might want to understand equivalent commands under each OS before you do the migration.


Check this link.


http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9d5.shtml


HTH


PS: please remember to rate helpful replies!

Correct Answer by Georg Pauwen about 11 years 8 months ago

Hello Jeff,


are you looking for this ?


Catalyst OS to Cisco IOS Configuration Converter


http://www.cisco.com/cgi-bin/Support/CatCfgConversion/catcfg_xlat.pl


Regards,


GP

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
apmorgan Mon, 01/09/2006 - 07:12
User Badges:


This tool does not seem to be working at least over the last 5 days.


I have tried to upload and convert 8.3 catos config, and also tried cutting and pasting in the conversion box.


Browser status says: Opening page http://...catcfg_xlat.pl..


But conversion never happens, browser just times out.

Anyone else having problems?


mbernhardt Mon, 01/09/2006 - 09:20
User Badges:

Yes, I had the same problem. I finally wrote a perl script to do the port-level configuration because I had a ton of ports. Adjust as you see fit:

open (PORTS,"sw2.txt");

open (NEWSW1,">sw2-new.txt");

@ports = ;

foreach (@ports) {

($port,$desc,$conn,$vlan) = /(\d+\/\d+)\s+(.*)\s+(connected|notconnect)\s+(\d+)\s+/;

if ($conn) {

print NEWSW1

"interface g$port\n desc $desc\n switchport host\n switchport access vlan $vlan\n no shutdown\n";

}

}


Correct Answer
thisisshanky Wed, 12/21/2005 - 13:04
User Badges:
  • Purple, 4500 points or more

Please be aware that not all configs will convert properly with this tool You might want to understand equivalent commands under each OS before you do the migration.


Check this link.


http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9d5.shtml


HTH


PS: please remember to rate helpful replies!

Actions

This Discussion